Lettuce freezing in the crisper while the milk goes warm, a freezer that buzzes all night, or a puddle spreading under the door? One of our technicians visits your Barrie home, traces the fault to a specific component and brings both compartments back to the right temperature.
French-door, side-by-side and top-freezer models around the city keep failing in the same handful of ways. Each card lists what we test first.
Frost choking the evaporator so air can't flow, an air flap jammed shut between the two sections, or a fan motor that quit.
Lint-covered coils near the floor, a door seal gone slack, or a thermistor feeding the board the wrong number.
The defrost channel has iced shut, the drip pan cracked, or a fitting on the water connection has worked loose.
A fill line frozen solid, an inlet valve stuck shut, or an ice maker unit that quit cycling.
The start relay tries to kick the compressor on and fails, or the overload keeps tripping.
A control board that lost power, a loose harness at the hinge, or a failing user panel.
Fridge styles we fix
Whatever name is on the door, from budget basics to premium European models, our technicians have worked on plenty of them before.
GE and GE Profile fridges flag most problems with a two-letter code on the dispenser screen. Check yours before you call.
Power interrupted
The power dropped for a while. Tap any key to clear the message, then make sure the food stayed cold.
Try this firstDoor left open
One of the doors hasn't closed fully for a while. Shut every door firmly and check the seals.
Try this firstFreezer fan not running
The fan that moves cold air is not turning while the compressor runs, often because of ice.
Call a technicianDefrost didn't finish
The defrost cycle stopped early, so frost is building on the coils behind the freezer panel.
Call a technicianSabbath mode on
This is a setting, not a fault. Switch it off in the settings menu or the app.
Try this firstIce maker not responding
The main board has lost contact with the ice maker module.
Call a technicianCoil sensor out of range
Readings from the evaporator coil sensor fall outside the expected range.
Call a technicianCompressor drive fault
The compressor or its drive has failed and the fridge won't cool.
Call a technicianCode back after a sixty-second unplug, or not listed here? Ring us and we'll arrange a home visit.
(249) 294-4068Neighbours across Barrie with cold groceries again.
Freezer full of ice, fridge side barely cool. He cleared the frost, replaced the fan and explained what had caused it. Simple as that.
What I appreciated was the honesty. He said our old bar fridge in the basement wasn't worth fixing and didn't charge us for the visit beyond the diagnostic.
Each morning brought a fresh wet patch on the tile. The channel at the back had frozen over. One visit, and not a drop since.
Sometimes the culprit is just a knocked setting or an overloaded shelf. Try these before booking.
Thermostat set right
Fresh food side near 3°C and freezer near -18°C; a knocked dial is easy to miss.
Air vents clear
Nothing pushed up against the openings inside either compartment.
Coils dust-free
Kick plate popped off and the coils vacuumed clean.
Doors closing fully
No shelf or drawer stopping the door, and the seal sitting flat all round.
Leave these to us
Still not cooling?
Certified and insured refrigerator technicians handle the rest.
Fill in your details and mention which machine has stopped cooperating. We call back to arrange an hour that works for your household.
Prefer the phone?
(249) 294-4068Request a Visit
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
