Glasses streaked with film, murky water pooled beneath the racks, or a drawer stopping halfway through its program? A technician drops by, identifies what broke and has the dishes coming out clean.
Standard built-ins and DishDrawer models across Barrie tend to show these six faults, each listed with our first checks.
A filter crammed with scraps, glass fragments caught by the pump blades, or a one-way flap stuck shut.
Grit lodged in the nozzles, a wash motor losing power, or an inlet that barely opens.
A flattened gasket around the door, a split sump seal, or a fitting below the tub that worked loose.
A burned-out element, or a sensor that never signals it to start.
A door latch with worn contacts, a faulty touch panel, or the flood float in the base lifting.
Bones or seeds stuck by the chopper, pump bearings wearing out, or the motor straining to turn.
Dishwasher styles we fix
Whatever name is on the door, from budget basics to premium European models, our technicians have worked on plenty of them before.
Fisher & Paykel DishDrawer models show a short code in the drawer display when a program stops. These are the ones we see most.
Water fill failure
Make sure water is turned on under the sink and the inlet line lies flat, then run the drawer again.
Try this firstDrain failure
Remove and rinse the filter, clear any debris from the sump and check the drain line has a high loop.
Try this firstDrawer communication error
Open the drawer all the way, then close it firmly to reconnect it.
Try this firstOverflow detected
Shut off the water first. A flood in the base needs to be checked by a technician.
Call a technicianHeating failure
The water isn't heating as expected, which points to the element or a sensor.
Call a technicianWash pump fault
The wash pump or its motor isn't running properly.
Call a technicianNot on this list, or back the moment you reset? Ring our office for a home visit.
(249) 294-4068Kitchens around Barrie with spotless racks again.
Our DishDrawer kept stopping with an error. He found the bottom drawer had a worn seal and fixed both drawers in one visit.
Showed up early, laid down a mat, fixed the leak and wiped up after himself. Couldn't ask for more.
Plates came out greasy for weeks. The spray arms were blocked solid. Cleaned out, tested, and the dishes sparkle again.
A stalled dishwasher sometimes has a simple cause. Check these points before calling.
Child lock off
Lock disabled and the dishwasher breaker reset.
Filter rinsed
The round filter beneath the lower basket removed, washed and refitted.
Spray arms clear
Both arms spin by hand and the nozzles aren't blocked.
Hot water first
The sink tap run until it's hot, just before you press Start.
Leave these to us
Glasses still cloudy?
Certified and insured technicians on our team can take it from there.
Fill in your details and mention which machine has stopped cooperating. We call back to arrange an hour that works for your household.
Prefer the phone?
(249) 294-4068Request a Visit
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
